>Voltage 220V AC +15% (115V AC 60 HZ Optional)
>Frequency 50 Hz Single Phase
>Operating temperature -20° to 55° Centigrade
>Current consumption 80 VA typical
>Environmental Waterproof housing. Conformal coating on all printed circuit boards.
>Safety Approval Certified to meet CE standards
>Cabinet dimensions 930mm (high) x 345mm (wide) x 380 (deep)
>Material 1.6mm mild steel. (304 Stainless steel optional)
>Finish Epoxy powder coated
>Standard Colours Yellow, Red or White. Other RAL colours available on application.
>Motor Torque motor/gearbox combination with built-in capacitor
>Motor Speed TM 3.0 has approx. 3.0 seconds raiser/lower. TM 1.2 has approx. 1.2 second raise/lower
>Reversible Option Configurable for left or right hand lanes.
>Power-Fail Protection Automatic arm raise on power fail.
>Access Side door 280mm x 650mm.
Gate Arm
>Lengths 3 Meter, 4.5 Meter or 6 Meter
>Material Extruded aluminium tubing
>Finish White epoxy powder coated, red reflective tape
Motor
>Opening times 3 seconds TM 3 1.2 seconds TM 1.2 (note TM 1.2 can only be used with 3 meter arm )
>Type Torque motor/gearbox combination
>Output torque 35 N.M. 10 RPM 15 N.M. 23 RPM Approximately
>Shaft speeds 10 RPM 3 second opening time. 25 RPM 1.2 second opening time.
Drive Mechanism
>Arm arc travel 87.5° to 92.5°
>Arm drive Offset lever arm drive with over centre lock at raise and lowered positions
>Arm damping Rubber buffer end stops
>Arm counterbalance Dual adjustable counter balance springs, tension according to arm length
>Arm position Configurable for right hand or left hand applications
>Power fail protection Settable for arm raise or arm lower on power fail
Electronic Control Logic
>Technology Digital, microcontroller-based logic
>Isolated Inputs Non-memory, memory, closing, remote raise/lower, auxiliary
>Outputs direct motor drive, ticket dispenser interlock, counters, Auxiliary 12 Volt DC power 100 Ma
>Counters On board or remote, both optional
>Loop Detectors Pluggable optional closing and auxiliary detectors